Uv fingernail light brand for pools

Due to the efficiency and convenience of ultraviolet disinfection by people gradually recognize and promote, more and more ultraviolet disinfection lamp sterilization products are rapidly into the daily life of the public, but in the use of the process also should pay attention to the safety of the ultraviolet disinfection lamp, so how to use the ultraviolet disinfection lamp correctly?Correct use of ultraviolet disinfection lamp1. The ultraviolet light source cannot directly illuminate the human body. Also, do not look directly at the ultraviolet light source. Should wear protective glasses or sunglasses when operating ultraviolet disinfection lamp, because ultraviolet irradiation may cause skin erythema, eye conjunctiva stimulation and easy to fatigue; Ultraviolet disinfection process will produce a certain amount of ozone, should be in the end of disinfection immediately after the window ventilation.2. Install ultraviolet equipment in a standard way. Ultraviolet disinfection lamp disinfection usually USES ultraviolet ray with wavelength of 253.7nm to sterilize. There are certain requirements for the use of space and height, and the sterilization effect should be better if the ultraviolet disinfection lamp is installed in the irradiation range of 1.8m to 2m high and 1.2m around the ground.3. When using ultraviolet disinfection, the control switch should be independently separated from the lighting switch, and marked with a clear warning label, the installation height should be higher than the general lighting is appropriate, the control can be used timing control, or increase the human body sensor, the light to ensure the safety of the use of ultraviolet disinfection lamp, to avoid accidents.4. In order to ensure the ultraviolet radiation intensity and effect, the surface of the ultraviolet disinfection lamp should be kept clean. In use process, should keep the surface of antiseptic ultraviolet disinfection lamp clean, if discover lamp tube surface has dirt, grease, answer to turn off power in time shut down wipe, the ultraviolet disinfection lamp that suggests frequent use needs to be wiped with 75% alcohol every week; When indoor air is disinfected with ultraviolet disinfection lamp, the room should be kept clean and dry to reduce dust and water mist. The irradiation time should be appropriately extended when the temperature is lower than 20℃ or higher than 40℃ and the relative humidity is more than 60%.5. Calibration of ultraviolet intensity meter (intensity test) at least once a year. Specific parameters please consult manufacturers and dealers.Method of measuring the intensity of ultraviolet disinfection lampsThe ultraviolet disinfection lamp tube in use should be in 3 ~ 6 months with ultraviolet radiation illuminance meter to make an intensity detection, with ultraviolet radiation illuminance meter to make a measurement calibration, in order to maintain accuracy, find the ultraviolet disinfection lamp tube with unqualified intensity should be replaced in time.We do it by chemical indicator CARDS1. After opening the ultraviolet disinfection lamp tube for 5 minutes, place the chemical card at a vertical distance of 1 meter under the ultraviolet disinfection lamp, with the patterned side of the chemical indicator card facing up;2. The ultraviolet disinfection lamp is irradiated for 1 minute (the chemical card will have different color changes);3. Observe the color block of the indicator card and compare it with the standard color block, then read the irradiation intensity.The test results take 10w as an example:1. The new ultraviolet disinfection lamp shall be qualified if its ultraviolet illumination is not less than 30uw/cm;2. If it is the ultraviolet disinfection lamp tube in use, it should not be less than 20uw/cm to be qualified.Usages of ultraviolet disinfection lamp1. Ultraviolet disinfection lamp device: every 10 meters can be installed 38 watt of ultraviolet lamp tube, useful interval does not exceed two meters. Together, it is necessary to equip indoor temperature and moisture meters. Ultraviolet disinfection lamp should be careful to use.2. When used for air disinfection should be closed doors and Windows, since the light is bright 5-7 minutes after the timing, each disinfection time shall not be less than 60 minutes, ultraviolet disinfection lamp shine in the process to stop the personnel into the room, it is necessary to enter, should first stop ultraviolet disinfection lamp shine, especially young unmarried lady remember this.3. With ultraviolet disinfection lamp disinfection article, the article spread out or hang, expand shining surface, useful interval is one meter, shine 30 minutes or so can.4. When using ultraviolet disinfection lamp, should insist on the cleanliness of the environment, the air can not have dust and water mist, etc., when the indoor temperature is lower than 20 degrees Celsius or the relative humidity exceeds 50%, should extend shining time. After scrubbing the ground to wait on the ground after the dry ultraviolet lamp disinfection.5. Ultraviolet disinfection lamp tube appearance should adhere to clean, no dust, weekly with 95% ethanol cotton ball scrub, and better records.6. Ultraviolet to human skin mucous membrane is bound to harm, the use of ultraviolet disinfection lamp to pay attention to do a good job of protection, the eyes can not direct at the ultraviolet light source, otherwise the eyes will be damaged.For more information about Ultraviolet disinfection lamp, please contact Tepro ultraviolet disinfection lamp suppliers.

Affected by the COVID-19, ultraviolet disinfection lamp in the sterilization products are very popular on the market, and the ultraviolet ray sterilizing lamp mainly divided into: high voltage, medium voltage and low voltage three kinds of disinfection, ultraviolet disinfection lamp, is to use ultraviolet light to kill bacteria breeding, buds, branches of bacillus, coronavirus, fungi, such as rickettsia and chlamydia bacteria, so ultraviolet disinfection lamp has been used in what respect?Application of ultraviolet disinfection lamp(1) ultraviolet disinfection lamp in the surface of the application of sterilizationThis sterilizer is mainly used in the fields of food, electronics, semiconductor, liquid crystal display, plasma TV, crystal vibrator, precision device, chemical industry, medicine, health care, biology, beverage, agriculture and so on. Because the UV light source is irradiated on the surface of food, materials, etc., it has a fast and efficient bactericidal effect without pollution, and can maintain the high quality of products. Therefore, it is faster than the traditional sterilization method, on the surface of the sterilization of the speed of sterilization, but also can be carried out continuous processing and batch processing, and in the operation of simple and convenient, environmental protection without secondary pollution and other characteristics.(2) Application of ultraviolet disinfection lamp in water treatmentMainly USES the ultraviolet disinfection lamp to carry on the water treatment method: the immersion type and the overcurrent two kinds, among them if directly puts the ultraviolet lamp into the water is the immersion type; However, if the uv lamp is put into the casing for use, it is overcurrent. At present, the method of overcurrent is basically adopted. Because the principle of overcurrent equipment is the water flow through the pump pressure, so the flow can be through the ultraviolet quartz casing, but because of the ultraviolet light produced by the ultraviolet disinfection of the water, sterilization. So its characteristic is the speed of water flow is very fast, the time that flows in quartz jacket commonly is not more than 1s, because this asks the ultraviolet intensity of antiseptic lamp wants very high. (3) Application of ultraviolet disinfection lamp in medical treatmentThis mainly used ultraviolet disinfection lamp to sterilize the air, and here the use of static direct exposure to the air and the flow of air disinfection method these two methods. Because static air is direct illuminate method basically USES ultraviolet ray disinfection lamp direct illuminate to undertake antiseptic, but drawback is the place that does not illuminate namely is disinfected cannot, and the person cannot be in the spot when disinfecting. And the flow of air disinfection law is the use of dynamic air disinfection machine, this disinfection machine can just fill the shortcomings of the above two points. The principle of mobile air sterilizer is through the indoor air for mutual circulation, and then the air sterilization to achieve the purpose of indoor air disinfection. The structure of this sterilizer is basically the housing of household air conditioning. The mobile air sterilizer, previously used only in hospitals, has been widely used in homes, offices and bulletin boards. The function above also changes the diversification, for example: can apply in the health care, the prevention function, becomes the health related product. How long does it take to sterilize ultraviolet disinfection lamp? Doors and Windows should be closed when used for air disinfection, each disinfection time shall not be less than 60 minutes, since the light on 5-7 minutes after the timing, the irradiation process is prohibited to enter the room, because the work needs to enter, should stop irradiation, especially young unmarried nurses remember this. When disinfecting articles, spread the articles or hang them, expand the irradiation surface, the effective distance is one meter, irradiation not less than 30 minutes. Application of uv ultraviolet sterilization effect of bacteria. Method of e. coli, proteus, staphylococcus aureus, staphylococcus aureus, bacillus subtilis, white light 20 min, 30 min, respectively 40 min, 50 min, 60 min. Results different bacterial resistance to ultraviolet, 30 min after the ultraviolet irradiation, escherichia coli and proteus all death irradiation 40 min, staphylococcus aureus, white staphylococcus all death irradiation 60 min, bacillus subtilis all death conclusion ultraviolet disinfection, exposure time should be greater than 60 min. Ultraviolet disinfection lamp disinfection needs 60 minutes. Please use disinfection with caution disinfection lamp of ultraviolet ray. Ultraviolet disinfection lamp is the short-wave ultraviolet ray (UVC) that USES the 254nm that mercury lamp gives out to be disinfected mostly, this kind of short-wave ultraviolet ray energy is bigger, if do not have protection, can cause direct harm to human body, if the eye, skin is burned seriously, cause skin cancer even.

With the increasing needs of uv sterilizer in the market, its outlook is quite positive. Due to the finest quality and affordable price, this product sells very well. As it is known by more customers at home and abroad, the uv sterilizer's quantity demanded is also increasing. It is of high durability and great reliability which is highly recommended by more customers. People from over the world begin to pay great attention to it. As a qualified manufacturer of producing uv lamp kopen, Tepro (China) Co., Ltd. has served the market for many years and has been recognized as a competitive supplier. Tepro's sterilizing lamp series include multiple types. Teprowhere can i buy a uv light is made by optical, mechanical, and quality assurance engineers. Their expertise in a wide range of imaging applications and technologies ensures the quality of this product. It is also used for pre-curing in the printing and silk screen industries. Quality is what Teproproduct can do for customers. It is sturdy, efficient and has an aesthetically pleasing design.Considerate service for customers has always been our teamproviding for years. Call now!

There a wide range of services offered to support the better use of uv sterilizer. For example, we will provide customization service for product packaging, which helps increase product safety during shipment. We also set a warranty policy for customers in need of product replacement and repair. Once there are some imperfections found on the product, we can arrange a free replacement or repair them with the help of our experienced technicians. Supplying these services, we receive more high remarks from customers all over the world. Tepro (China) Co., Ltd. specially focuses on designing and manufacturing buy ultraviolet light. We are known as a manufacturer in China market. Tepro's uv gel nail dryer series include multiple types. Once the Teprouv light heat production is completed, the quality assessment will be carried out. We will strictly check fiber strength, water shrinkage, colorfastness, weaving strength and other parameters. It is perfect for applications that require "around-the-clock" use. This product can significantly speed up production time. Because it reduce the chance of human errors that will probably delay production time. The compact units of this product require minimum space and simple installation.We target becoming a wide famous uv sunlight lamp supplier in the next future. Inquiry!